Step 1: Preparing Work Area Support and remove wheel using jack and jack stands. (optional)

Care & Cleaning: Bushwacker fender fl ares are built to last; any detergent you use to wash your vehicle is suffi cient to clean the fl are. Do not use any harsh abrasive detergents.

Care & Cleaning: Bushwacker fender flares are built to last; any detergent you use to wash your vehicle is sufficient to clean the flare. Do not use any harsh abrasive detergents.

Care & Cleaning: Bushwacker fender fl ares are built to last; any detergent you use to wash your vehicle is suffi cient to clean the fl are. Do not use any harsh abrasive detergents.

Toyota Pocket Style® Fender Flares Set of 4 Set Part #31920-02 Rev-12 07/18/2017 For complete fitment info visit : www.bushwacker.com

Rear Flare Installation Procedures (Driver’s Side): Holding fl are in position on fender, use a grease pencil to mark six hole locations.

A)Bushwacker only approves installing the flares according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the …

Remove the fl are. Using the marks made in step 18 as a guide, measure inward from the outside edge of the fender to verify proper depth of original marked location. Mark must be minimum of 22mm in …

Front Flare Installation Procedures (Passenger’s Side): Remove fi ve factory screws with a 7/32” socket wrench. Remove two rear most factory screws with 9/32” socket wrench. Save screws for reinstallation.

FRONT MAIN & REAR FLARE ONLY: Place a Nut (NU1-0019) over the end of each Bolt and tighten, using a 1/2” wrench for the Nut and the supplied Torx Bit (SW1-0052) for the Bolt. Repeat for …